in the market to sell Maifan stone non-stick pan, is as shown in figure:

maifan stone is like this:

yes, from the visual effect, they are the same.

maifan stone non-stick pan is no maifan stone ingredients, at best can only say that it is a coating like maifan stone non-stick pan.

why do you say maifanshi nonstick pan is no maifanshi ingredients?

because, to be added to the surface of the pot, the stone must be added in the form of powder. The powder of the stone is gray (according to the origin, the color is different), and it is a uniform gray powder. If it is attached to the pot, it is a gray coating, not similar to the textured stone.

as a matter of fact, maifan stone non-stick pan is a special coating process with paint sprayed into maifan stone effect, is how to spray?

the choice of paint is used for the inner coating of the pot. At present, the mainstream is Teflon paint and ceramic paint, both of which can spray the effect of medical stone.

Teflon paint spraying Maifanite effect coating process:

first: pot sandblasting, spray primer, baked 150-180 degrees, (primer color can be adjusted).

second: cooling to 40-60 ℃,

third: on the sprayed primer, use several colors of paint (usually gray, yellow, white, black, we call it dot, it is the same system as the topcoat) and spray it in the form of sprinkle dot.

the fourth, spray topcoat, wet spray wet form spray surface and point.

5: Put it into a low-temperature oven and bake at 150-180 degrees. During the baking process, the color leveling of these points will partially melt to form a pattern similar to that of medical stone.

sixth: finally in the 380 degree oven fully cured.

ceramic coating spraying medical stone effect coating process:

first: the ceramic coating is well cured. After sandblasting, the workpiece is preheated and the primer is sprayed (the color of the primer can be adjusted).

the second: on the sprayed primer, use several colors of paint (usually gray, yellow, white, black, we call it dot, it is the same system as the topcoat), and spray it in the form of sprinkle dot.

the third, spray top paint, wet spray wet form spray bottom, surface and point.

4: Put it into a low-temperature oven and bake at 150-180 degrees. During the baking process, the color leveling of these points will partially melt to form a pattern similar to that of medical stone.

fifth: finally in 22-280 degree oven fully cured.

The above is the primer-> point-> topcoat, so that the surface is relatively flat and there is not much uneven feel.

If you need the effect of uneven feel, you can choose the order of primer-> topcoat-> dot.